2C reversible ratchet 1/4": To DIN 3120 - A 6.3, ISO 1174, lever for right and left-hand operation, push button release, fine-toothed, oval form, 2-component-handle, Square plug-in handle 1/4", 1-component handle with female square, Socket 1/4" hexagon: Metric, short, to DIN 3124, ISO 2725, Screwdriver bit socket 1/4" for in-hex screws: Pressed-in, phosphated pin, Screwdriver bit socket 1/4" slotted, PH, PZ, TX with drill hole: Pressed-in, phosphated pin, Socket extension 1/4", Sliding T-handle with slide 1/4": Acc. to DIN 3122, ISO 3315, Universal joint 1/4": Joint bolted on, design to DIN 3123 - C 6.3, 2C reversible ratchet 1/2": To DIN 3120 - A 12,5, ISO 1174, lever for right and left-hand operation, push button release, fine-toothed, oval form, 2-component-handle, Socket extension 1/2", Sliding T bar 1/2", with slide, to DIN 3122, ISO 3315, Universal joint 1/2": Joint bolted on, design to DIN 3123 - C 12,5, Socket, hex: Metric, short, to DIN 3124, ISO 272, Screwdriver bit socket 1/2" for in-hex screws: Pressed-in, phosphated pin, Combination spanner: To DIN 3113, Form A ISO 3318, ISO 7738, ring side angled 15B0 jaw position, surface matt satin, plate-chromed, Hexagon socket key set: To DIN ISO 2936, hardened throughout, phosphated, Chrome-vanadium steel, Water pump pliers: To DIN 8976 Form C, lengthways-serrated gripping surfaces, box joint, 7 settings, chrome vanadium steel, powder-coated, Combination pliers: To DIN ISO 5746, inductively hardened cutting edges, 2-component-handle, forged, Bent nose telephone pliers: To DIN ISO 5745, straight gripping surfaces, lengthways-serrated, inductively hardened cutting edges, 2-component-handle, forged, Side cutters: To DIN ISO 5749, slender head, inductively hardened, long cutting edges, 2-component-handle, forged, Engineersb hammer: Forged hammer head of tempered steel, inductively hardened striking surfaces, to DIN 1041, ash handle, paint-coated shaft end, ring wedge, Flat cold chisel, flat oval: To DIN, cutting edge and head ground, impact end tempered, chrome-vanadium steel, Cross-cut chisel, flat oval: To DIN 6451, cutting edge, sides and head ground, impact end tempered, chrome-vanadium steel, Hexagonal punch: To DIN 6458, impact end annealed, chrome-vanadium steel, Centre punch, hexagonal: To DIN 7250, impact end annealed, chrome-vanadium steel, Pin punch, octagonal: To DIN 6450, impact end annealed, chrome-vanadium steel, 2C screwdriver slotted and PH: To DIN, high-grade chrome-molybdenum steel blade, chrome-plated, phosphated driven tip, 2-component-handle, 5-edge grip head, elongated hole in handle, 2C screwdriver TX: Chrome-molybdenum steel blade, chrome-plated, phosphated driven tip, 2-component-handle, 5-edge grip head, elongated hole in handle, Tape measure: ABS dual-material housing, clip, nylon-coated tape, mm-graduation, with tape rewind and lock, magnetic stop, Accuracy Class II